RUTX09


MOBILE
Mobile module4G (LTE) – Cat 6 up to 300 Mbps, 3G – Up to 42 Mbps
SIM switch2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail
StatusSignal strength, SINR, RSRP, RSRQ, Bytes sent/received, connected band, carrier aggregation, IMSI, ICCID
SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET, Email to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS auto reply
USSDSupports sending and reading Unstructured Supplementary Service Data messages
Black/White listOperator black/white list
Multiple PDNPossibility to use different PDNs for multiple network access and services
Band managementBand lock, Used band status display
APNAuto APN
Bridge modeDirect connection (bridge) between mobile ISP and device on LAN
ETHERNET
WAN1 x WAN port (can be configured as LAN) 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover
LAN3 x LAN ports, 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover
NETWORK
RoutingStatic routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP)
Network protocolsTCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake on LAN (WOL)
VoIP passthrough supportH.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
Connection monitoringPing Reboot, Wget reboot, Periodic Reboot, LCP and ICMP for link inspection
FirewallPort forwards, traffic rules, custom rules
DHCPStatic and dynamic IP allocation, DHCP Relay, Relayd
QoS / Smart Queue Management (SQM)Traffic priority queuing by source/destination, service, protocol or port
DDNSSupported >25 service providers, others can be configured manually
Network backupVRRP, Mobile and Wired WAN options, each of which can be used as an automatic Failover
Load balancingBalance Internet traffic over multiple WAN connections
HospotInternal/external Radius server, captive portal, built in customizable landing page
SSHFSPossibility to mount remote file system via SSH protocol
SECURITY
AuthenticationPre-shared key, digital certificates, X.509 certificates
FirewallPre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
Attack preventionDDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
VLANPort and tag based VLAN separation
Mobile quota controlCustom data limits for both SIM cards
WEB filterBlacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
Access controlFlexible access control of TCP, UDP, ICMP packets, MAC address filter
VPN
OpenVPNMultiple clients and a server can run simultaneously, 12 encryption methods
OpenVPN EncryptionDES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC
IPsecIKEv1, IKEv2, with 5 encryption methods for IPsec (DES, 3DES, AES128, AES192, AES256)
GREGRE tunnel
PPTP, L2TPClient/Server instances can run simultaneously, L2TPv3 support
StunnelProxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
DMVPNMethod of building scalable IPsec VPNs
SSTPSSTP client instance support
ZeroTierZeroTier VPN client support
WireGuardWireGuard VPN client and server support
MODBUS
MODBUS TCP SLAVE
ID filteringRespond to one ID in range [1;255] or any
Allow remote accessAllow access through WAN
Custom registersMODBUS TCP custom register block, which allows to read/write to a file inside the router, and can be used to extend MODBUS TCP slave functionality
MODBUS TCP MASTER
Supported functions01, 02, 03, 04, 05, 06, 15, 16
Supported data formats8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
MQTT GATEWAY
GatewayAllows sending commands and receiving data from MODBUS Master through the MQTT broker
DNP3
Supported modesTCP Master, DNP3 Outstation
DATA TO SERVER
ProtocolsHTTP(S), MQTT, Azure MQTT, Kinesis
MONITORING & MANAGEMENT
WEB UIHTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log
FOTAFirmware update from server, automatic notification
SSHSSH (v1, v2)
SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS autoreply
CallReboot, Status, Mobile data on/off, Output on/off
TR-069OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem
MQTTMQTT Broker, MQTT publisher
SNMPSNMP (v1, v2, v3), SNMP trap
JSON-RPCManagement API over HTTP/HTTPS
MODBUSMODBUS TCP status/control
RMSTeltonika Remote Management System (RMS)
SYSTEM CHARACTERISTICS
CPUQuad-core ARM Cortex A7, 717 MHz
RAM256 MB, DDR3
FLASH storage256 MB, SPI Flash
FIRMWARE / CONFIGURATION
WEB UIUpdate FW from file, check FW on server, configuration profiles, configuration backup
FOTAUpdate FW/configuration from server
RMSUpdate FW/configuration for multiple devices at once
Keep settingsUpdate FW without losing current configuration
FIRMWARE CUSTOMIZATION
Operating systemRutOS (OpenWrt based Linux OS)
Supported languagesBusybox shell, Lua, C, C++
Development toolsSDK package with build environment provided
LOCATION TRACKING
GNSSGPS, GLONASS, BeiDou, Galileo and QZSS
CoordinatesGNSS coordinates via WebUI, SMS, TAVL, RMS
NMEANMEA 0183
Server softwareSupported server software: TAVL, RMS
GeofencingConfigurable multiple geofence zones
USB
Data rateUSB 2.0
ApplicationsSamba share, USB-to-serial
External devicesPossibility to connect external HDD, flash drive, additional modem, printer
Storage formatsFAT, FAT32, exFAT, NTFS (read-only), ext2, ext3, ext4
INPUT/OUTPUT
Input1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high
Output1 x Digital Output, Open collector output, max output 30 V, 300 mA
EventsSMS, Email, RMS
I/O jugglerAllows to set certain I/O conditions to initiate event
POWER
Connector4 pin industrial DC power socket
Input voltage range9 – 50 VDC, reverse polarity protection, voltage surge/transient protection
PoE (passive)Passive PoE. Possibility to power up through LAN port, not compatible with IEEE 802.3af, 802.3at and 802.3bt standards
Power consumption9 W Max
PHYSICAL INTERFACES (PORTS, LEDS, ANTENNAS, BUTTONS, SIM)
Ethernet4 x RJ45 ports, 10/100/1000 Mbps
I/Os1 x Digital Input, 1 x Digital Output on 4 pin power connector
Status LEDs3 x WAN type, 2 x Mobile connection type, 5 x Mobile connection strength, 8 x LAN status, 3 x WAN status, 1x Power
SIM2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders
Power1 x 4 pin DC connector
Antennas2 x SMA for LTE, 1 x SMA for GNNS
USB1 x USB A port for external devices
ResetReboot/User default reset/Factory reset button
Other1 x Grounding screw
PHYSICAL SPECIFICATION
Casing materialAluminium housing with DIN rail mounting option
Dimensions (W x H x D)115 x 44.2 x 95.1 mm
Weight455 g
Mounting optionsDIN rail, flat surface placement
OPERATING ENVIRONMENT
Operating temperature-40 C to 75 C
Operating humidity10 % to 90 % non-condensing
Ingress Protection RatingIP30
REGULATORY & TYPE APPROVALS
RegulatoryCE/RED, EAC, RoHS, WEEE
EMI IMMUNITY
StandardsDraft EN 301 489-1 V2.2.0, Draft EN 301 489-19 V2.1.0, Draft EN 301 489-52 V1.1.0
EN61000-4-2:2009ESD
RSEN 61000-4-3:2006 + A1:2008 + A2:2010
EFTEN 61000-4-4:2012
Surge protectionEN 61000-4-5:2014
CSEN 61000-4-6:2014
DIPEN 61000-4-11:2014
RF
StandardsEN 301 908-1 V11.1.1, EN 301 908-2 V11.1.1, EN 301 908-13 V11.1.2, EN303 413 V1.1.1
SAFETY
StandardsIEC 62368-1:2014, EN 62368-1:2014 + A11:2017
EN 50665:2017, EN 62311:2008

Povezani izdelki

RUT200
RUT901
RUT906
RUTX08